Type 125, Adjustable Knee Piece Ø48,3

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Round tube D=48.3mm
wall thickness 2.9 mm
painted black with powder
maximum profile length 3 m

Adjustable Two Socket Cross. This variable angled clamp may be used at any selected angle between 30 and 45 degrees. Type 7 can be used for the top rail.

Long Tee. Similar to Type 2. This fitting can be used where a join is required in the horizontal tube.

Clamp-On Crossover. 90° crossover joint fitting for adding to an existing structure.

Collar. Support fitting to increase the slip resistance of fittings that are under high loads.