40x40 mm

Short T-piece - 40 mm. Forms a perpendicular connection between two tubes. Upper fitting for straight, horizontal railing supports. This fitting can not be used for horizontal tube connections in the fitting itself.

Long T-piece. This fitting can be used where a join is required in the horizontal tube.

Knee piece 90° - 40 mm. Elbow fitting (90°) as end stop for the overhead rail.

Straight Coupling. Joint clamp for tubes of the same diameter. Do not use for heavy vertical loads. Alternative clamp is Type 9 used as an internal spigot.

Square footplate - 40 mm. Use this clamp for positioning constructions. Do not use as a basis for supporting safety railings and the like.

Rectangular Base Flange. Strong baseplate to support vertical post. Vertical wide rib with two setscrews increases the strength of the clamp. The fixing holes in the base flange should be in line with the applied load.

Three-way elbow 90° - 40 mm. Angle connection clamp (90°) for corners of overheads and all other angled connections.

Angle of continuous upright - 40 mm. Corner connection (90°), where the vertical tube runs through the clamp.

Two Socket Cross - for tube 40x40 mm. 90°- joint clamp between the middle rail and an upright on railings.

Side Outlet Tee - 40 mm. 3-direction clamp used to fix uprights with 3 horizontal tubes that are perpendicular to each other. The upright tube passes through the clamp.

Four Socket Cross. 4-direction clamp used to fix uprights with 4 horizontal tubes that are perpendicular to each other. Upright tube passes through the clamp. Please note: that rust may develop when used outdoors.

Crossover 90°. Crossover clamp (90°). Used for long tube intersections with uprights where decreasing cutting cost and increasing strength of the system with continuity of the tube is desired.

Type 34, Handrail support - 40 mm. To attach railings and constructions to walls.

Male Single Lug. Also used for fixing panels and boards.
Suitable for square tube 40x40 mm

Female Single Socket. Often used together with other brackets, such as Type 36, 38, and 40. One part of swivel fitting, not generally used alone.

Single Swivel. Swivel fitting for variable angle fixing.

Type 55, Eyelet part single lip - 40x40 mm. Tubefitting for fixing panels.

Collar plate double sided lip - 40mm. Tubefitting for fixing panels.
Suitable for square tube 40x40 mm

Collar Plate Double Side 90°. Panel fixing with two lugs also used for locking gates.

Hook twisted - 40 mm. Suited for making coat hangers and the like.
Suitable for square tube 40x40 mm

Steel galvanized square 40 mm tube profile / socket of 2 mm thickness. This profile has a standard trade length of 6
meters, but can always be cut to size for you. Suitable for our square tubefittings.
Black

Maximum length for shipping by courier is 2 meters!

Steel galvanized square 40 mm tube profile / socket of 2 mm thickness. This profile has a standard trade length of 6
meters, but can always be cut to size for you. Suitable for our square tubefittings.

Maximum length for shipping by courier is 2 meters!