Tube Fittings

The clamps are made of hot-dip galvanized malleable iron, painted black. Not suitable for outdoor use! Comply with TÜV requirements.

Short T-piece - 40 mm. Forms a perpendicular connection between two tubes. Upper fitting for straight, horizontal railing supports. This fitting can not be used for horizontal tube connections in the fitting itself.

Short Tee. Provides a perpendicular connection between two tubes. Top fitting for straight and level railing uprights. This fitting cannot be used to join a horizontal tube within the fitting.

Aluminum cap used to plug the end of the tube.

The clamps are made of hot-dip galvanized malleable iron, durable, corrosion-resistant and long-lasting. Comply with TÜV requirements.

Slope Elbow 90° Variable angle 0° - 11°. Elbow joint fitting used as an end fitting for the top rail up to 11°.

Klambrid on valmistatud kuumtsingitud tempermalmist ja värvitud mustaks. Vastupidavad, korrosioonikindlad ja pika kasutuseaga. Vastavad TÜV nõuetele.

Suitable for end connection.

Short Tee, long.
Same as type 2 but longer, with three adjusting screws.

Short Slope Tee Variable angle 0° - 11°. Top fitting for up to 11° uprights. This fitting can not be used to join horizontal tube within the fitting.

The clamps are made of hot-dip galvanized malleable iron, durable, corrosion-resistant and long-lasting. Comply with TÜV requirements.

Plastic cap used to plug the end of the tube.

Three-way elbow 90° - 40 mm. Angle connection clamp (90°) for corners of overheads and all other angled connections.

Reducing Short Tee. Used as Type 2. Rediction fitting makes it possible to design structures in two different tube diameters.

The clamps are made of hot-dip galvanized malleable iron, painted black. Not suitable for outdoor use! Comply with TÜV requirements.

Angle of continuous upright - 40 mm. Corner connection (90°), where the vertical tube runs through the clamp.

Short Tee 45°. Forms a connection between two tubes at an angle of 45°.

The clamps are made of hot-dip galvanized malleable iron, painted black. Not suitable for outdoor use! Comply with TÜV requirements.

Plastic cap Ø76,1 mm, black.
Plastic cap used to plug the end of the tube.

The clamps are made of hot-dip galvanized malleable iron, painted black. Not suitable for outdoors! Comply with TÜV requirements.

Two Socket Cross - 40 mm. 90°- joint clamp between the middle rail and an upright on railings.

Long Tee. Similar to Type 2. This fitting can be used where a join is required in the horizontal tube.

Plastic cap Ø90,2 mm, black
Plastic cap used to plug the end of the tube.

Round base plate open. This tubefitting is suitable for constructions where the pipe has to run through. Suitable for the use of e.g. intermediate shelves.
Another big plus of the black coating is, that the color gets into the material really deeply, which prevents the connectors from corroding too quickly. The tubefittings are equipped with black colored stainless steel adjusting screws with cutting edge.