Type 11 Square base plate Ø48,3

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Round tube D=48.3mm
wall thickness 2.9 mm
powder coated yellow
maximum profile length 3 m

Three Way Top Corner. Corner joint (90°) clamp used for top rail corners and any other rectangular system.

Reducing Crossover 90°. Used as Type 28. reduction fitting makes it possible to design structures in two different tube diameters - horizontal Ø48.3 and vertical Ø33.7mm.

Corner Swivel 90°. Swivel fitting for variable angle fixing for a corner post.

Butt joint for sloping sites, adjustable from 11° to 29°, often used to join intermediate uprights to top rails and middle rails to end uprights. This Interclamp cannot be used where through tube (sloping in photo) has to be joined within the fitting.