Type 123, Variable Elbow 40° - 70° Ø48,3

Base flange for sloping sites, adjustable from 11° to 29°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design.

Vertical Base Railing Support. Similar to Type 13, these applies even more to Type 13.

Adjustable Two Socket Cross. This variable angled clamp may be used at any selected angle between 30 and 45 degrees. Type 7 can be used for the top rail.

Reducing Crossover 90°. Used as Type 28. reduction fitting makes it possible to design structures in two different tube diameters - horizontal Ø60.3 and vertical Ø48.3mm.

Combi Socket Tee and Cross. Frequently used for racking. The upright hole can be changed according to the application. For shelved racking, the outside hole is upright, and for pallet racking the upright is inside the carrying rails.

Openable Short Tee 45°. Forms a connection between two tubes at an angle of 45°.