Type 22, Two Socket Cross, Ø48,3 mm

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Angle Cross 0°- 45°. Connection clamp between the middle rail and the railing posts of sloping railings up to 45°.

Add-on Short Tee. Forms a perpendicular connection between two tubes. Used for expanding and adapting existing structures.

Galv. Eves Fittings 27½°. This tube fitting is used for roof construction and is usually in combination with type 91.

Elbow 90°. Elbow joint fitting used as an end fitting for the top rail with different tube dimensions Ø42,4 mm and 48,3mm

Collar Plate Double Side 90°. Panel fixing with two lugs also used for locking gates.