Type 28, Offset Crossover 90° Ø48,3

Add-on Four Socket Cross. Openable 4-way clamp to connect vertical posts to 4 horizontal tubes that are at right angles to each other. The vertical tube runs through the clamp.

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Round tube D=48.3mm
wall thickness 2.9 mm
painted black with powder
maximum profile length 3 m

Adjustable Knee Piece. Variable elbow fitting. This tubefitting can make a minimum angle of 75 degrees to a maximum of 210 degrees.

Slope Railing Base - variable angle 0° - 11°. Base fitting for railings designed on slopes up to 11°.

Galv. Ridge Fittings 27½°. This tube fitting is used for roof construction and is usually in combination with type 85E.