Type 2, Short Tee, Ø48,3 mm

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Wall Flange. This clamp is used on structures where positional fixing is required. Do not use as a base flange to support guard railings or similar systems.

Side Outlet Tee. 3-direction clamp used to fix uprights with 3 horizontal tubes that are perpendicular to each other. Upright tube passes through the clamp.

Swivel Base. Used for an angled wall attachment or support for an upright post.

Elbow 90°. Elbow joint fitting used as an end fitting for the top rail.

Openable Short Tee 45°. Forms a connection between two tubes at an angle of 45°.