Type 24, Side Outlet Tee Ø48,3 mm

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Four Socket Cross. 4-direction clamp used to fix uprights with 4 horizontal tubes that are perpendicular to each other. Upright tube passes through the clamp.

Clamp-On Crossover. 90° crossover joint fitting for adding to an existing structure.

ATTENTION: The price is for one tube fitting. The figure shows a set of two fittings. Adjustable Swivel Tee. Always used in pairs to allow angle variation between 54 and 270 degrees. 608049B = 70° - 208° (min/max angle) 608049C = 71° - 217° (min/max angle) 608049D = 97° - 270° (min/max angle) 608049E = 54° - 215° (min/max angle)

Metal cap for Ø42,4 mm tube
Color: black

Cover caps are designed to close and finish pipe ends.
These caps are not intended to cover the clamp holes.

Elbow 90°. Elbow joint fitting used as an end fitting for the top rail with different tube dimensions Ø42,4 mm and 48,3mm