Type 36, Male Single Lug Ø48,3

Add-On Corner With Trough Tube 90°. Openable corner connection (90°), with the vertical tube running through the clamp.

Swivel Base Plate (Unisize). For fixing structures to wall or floor, usually used with Type 42.

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Angle Cross 0°- 45°. Connection clamp between the middle rail and the railing posts of sloping railings up to 45°.

Add-on Crossover 90°. Same tubefitting as type 28 but this tubefitting can be placed on an existing construction by means of a foldable part.

Reducing Crossover 90°. Used as Type 28. reduction fitting makes it possible to design structures in two different tube diameters - horizontal Ø48.3 and vertical Ø42.4mm.