Type 36, Male Single Lug Ø48,3

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Type 2230, 180° Swivel bearing for self closing gate Finish: untreaded aluminum

Short T-clamp 45°. Connects horizontal and vertical pipes at a 45° angle. The clamp is made of hot-dip galvanized malleable iron, durable, corrosion-resistant and long-lasting. Meets TÜV requirements.

Add-on Short Tee. Forms a perpendicular connection between two tubes. Used for expanding and adapting existing structures.

Type 35 handrail clamp, open. For attaching the handrail pipe to the wall. The clamps are made of hot-dip galvanized malleable iron, durable, corrosion-resistant and long-lasting. Comply with TÜV requirements.

Adjustable for slopes from 11° to 29°, often used between middle rail and uprights on sloping sites and often paired with type 253 or type 255. The through tube (vertical in photo) cannot be joined within the fitting.