Type 70, Single Sided Panel Clip Ø42,4

Crossover 90°. Crossover clamp (90°). Used for long tube intersections with uprights where decreasing cutting cost and increasing strength of the system with continuity of the tube is desired.

Reducing Crossover 90°. Used as Type 28. reduction fitting makes it possible to design structures in two different tube diameters - horizontal Ø42.4 and vertical Ø33.7mm.

Elbow 90°. Elbow joint fitting used as an end fitting for the top rail.

Collar. Support fitting to increase the slip resistance of fittings that are under high loads.

The 751 fitting is designed for intermediate support of horizontal galvanized handrail tubes where no joining of the tubes is required.

748 - DDA Assist Saddle Internal Swivel Bracket
To attach handrail to an upright at any angle.

Although the saddles type Assist fittings are primarily designed to fit snugly on Ø42.4 diameter tubes, they may also accommodate Ø48,3 mm tubes with a slight central gap when fitted.