Type 8V, Tubefitting sleeve with gradient Ø33,7/Ø26,9 mm

Add-on Side Outlet Tee. The same tube fitting as type 24, but this tube fitting can be placed on an existing construction by means of a foldable part on the vertical tube connector.

Plastic cap Ø76,1 mm, black.
Plastic cap used to plug the end of the tube.

Plastic cap for tube 40x100 mm
black

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Side Outlet Tee - 25 mm. 3-direction clamp used to fix uprights with 3 horizontal tubes that are perpendicular to each other. The upright tube passes through the clamp.

Crossover 90°. Crossover clamp (90°). Used for long tube intersections with uprights where decreasing cutting cost and increasing strength of the system with continuity of the tube is desired.