Road sign clamp 140 mm one-sided

When a vehicle collides with a road sign post, which is equipped with a spring, the road sign restores its upright position.
Suitable for traffic poles up to 1.6m long and Ø60mm in diameter
Tested: 70 km/h
Recommended areas of use: parking lots, separation islands, tramways, ring roads, etc.

Adapter is perfectly suited for a quick installation of traffic signs.

One-sided traffic sign clip for a 220mm pipe

The mounting sleeve is used to quickly install and remove road signs in places exposed to frequent damage, e.g. as a result of traffic accidents, by turning lorries, intentional damage or in places where signage is often changed.

Ground sleeve 76 x 400 mm cast iron, including tensioning nut and
PE-Clamping ring

Stainless steel band
w: 9mm t: 0,6mm l: 30 m
Compatible product: Stainless steel buckle 12 mm, G304, tootekood: ZS12(TS12)G304

Folding sign holder

For quick securing and marking of construction sites.

- footplate with anti-slip system, therefore no slipping on the construction site
- folds down undamaged during crash and thus increases safety enormously
- the shield holder consists of 40 x 40 square tube
- signs can be fixed with sign clamps or hooked into the lasered retaining contour
- usable height: 815 mm
- total height: 1100 mm
- weight 11.06 kg

The traffic sign is not included!