Type 12, Railing Base Flange Ø48,3

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Round tube D=48.3mm
wall thickness 2.9 mm
painted black with powder
maximum profile length 2 m

Corner Swivel 90°. Swivel fitting for variable angle fixing for a corner post.

Pin Hinge. Male hinge fitting, to be used in combination with type 62.

Straight Coupling. Joint clamp for tubes of the same diameter. Do not use for heavy vertical loads. Alternative clamp is Type 9 used as an internal spigot.

Two Socket Cross. 90° joint clamp between the middle rail and an upright on railings with different size Ø42,4mm/48,3 mm.