Type 3301, Wall bearing Ø 33,7 mm untreaded

Double body pipe fitting with three outlets and two 90° angles for connecting pipes. The continuous pipe and the end of the pipe are connected to the T by this pipe fitting, fixing the two halves. Finish: untreaded aluminum

Single-shell pipe fitting with three outlets for connecting two pipes with a 90° angle. The continuous pipe and the end of the pipe are connected to this pipe fitting with a T. The pipes are fixed with three screws. Finish: untreaded aluminum

One-body pipe fitting with an outlet for vertical attachment of the pipe to the surface. The pipe fitting has a round base plate with four holes for fixing. The end of the pipe is fixed in the pipe fitting with two screws. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening the two screws and sleeve nuts. The pipe is drilled twice with a diameter of 9.5mm. The screw and sleeve are connected to each other through the holes. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for attaching a pipe to a corner. The pipe connector consists of two individual parts, each with a wall mounting plate. The mounting plates can be variably rotated to any angle. This pipe connector can be used to attach pipes to inside and outside corners. Finish: untreaded aluminum

Single body pipe fitting with single pipe end outlet. This clamp can be combined with clamp 3316 to form a T or a cross. The pipe is fixed in the pipe fitting with a screw. Finish: untreaded aluminum