Type 3313,Wall bearing corner fastening Ø 33,7 mm untreaded

Single-shell pipe fitting with three outlets for connecting two pipes with a 90° angle. The continuous pipe and the end of the pipe are connected to this pipe fitting with a T. The pipes are fixed with three screws. Finish: untreaded aluminum

Single body four outlet pipe fitting for connecting three pipes with five 90° elbows. The continuous pipe and the two pipe ends are connected to this pipe joint at the corner. With this pipe fitting, the pipes are fixed with four screws. Finish: untreaded aluminum

One-body pipe fitting with an outlet for vertical attachment of the pipe to the surface. The pipe fitting has a round base plate with four holes for fixing. The end of the pipe is fixed in the pipe fitting with two screws. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening the two screws and sleeve nuts. The screw and sleeve are connected to each other through the holes. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for parallel attachment of a pipe to a surface. The pipe connector has a wall plate with two holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening a screw and sleeve nut. The screw and sleeve are connected to each other through the hole. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for connecting two pipes in the same axis. The pipe ends can be butted in the pipe connector. The pipes are fixed by two grub screws. Finish: untreaded aluminum