Type 3363, Angle-Connector 90° Ø 33,7 mm untreaded

Double body pipe fitting with three outlets and two 90° angles for connecting pipes. The continuous pipe and the end of the pipe are connected to the T by this pipe fitting, fixing the two halves. Finish: untreaded aluminum

Single body four outlet pipe fitting for connecting three pipes with five 90° elbows. The continuous pipe and the two pipe ends are connected to this pipe joint at the corner. With this pipe fitting, the pipes are fixed with four screws. Finish: untreaded aluminum

One-body pipe fitting with an outlet for vertical attachment of the pipe to the surface. The pipe fitting has a round base plate with four holes for fixing. The end of the pipe is fixed in the pipe fitting with two screws. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for vertically attaching a pipe to a surface. The pipe connector has a base plate with two holes for fastening. The pipe end is fixed in the pipe connector with a grub screw. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for parallel attachment of a pipe to a surface. The pipe connector has a wall plate with two holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening a screw and sleeve nut. The screw and sleeve are connected to each other through the hole. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a narrow base plate with two holes for fastening. The slotted end support is clamped tightly around the pipe end by tightening the screw and sleeve nut. Finish: untreaded aluminum