Type 3380, Connector, straightp Ø 33,7 mm untreaded

Double-shell pipe fitting with two outlets for connecting two pipes at a 90° angle. With this pipe fitting, two pipe ends are joined to form a 90° angle by attaching two halves. The pipe ends are drilled twice to Ø 9.5 mm. The screw and sleeve are connected to each other through holes. Therefore, the pipe fitting is suitable for higher tensile forces. Finish: untreaded aluminum

Single-shell pipe fitting with three outlets for connecting three pipes at three 90° angles. The pipe ends are connected to the corner (header) using this pipe fitting. With this pipe fitting, the pipe ends are fixed with three screws. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening the two screws and sleeve nuts. The screw and sleeve are connected to each other through the holes. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a narrow base plate with two holes for fastening. The slotted end support is clamped tightly around the pipe end by tightening the screw and sleeve nut. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a narrow base plate with two holes for fastening. The slotted end support is clamped tightly around the pipe end by tightening the screw and sleeve nut. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for a continuous pipe. This pipe connector is combined with article 3317 or 3316 to form a T or cross. With this pipe connector, the pipe is fixed by a grub screw. Finish: untreaded aluminum