Type 3371, Corner connection 90° header Ø 33,7 mm untreaded

Double body pipe fitting with three outlets and two 90° angles for connecting pipes. The continuous pipe and the end of the pipe are connected to the T by this pipe fitting, fixing the two halves. Finish: untreaded aluminum

Single-shell pipe fitting with three outlets for connecting two pipes with a 90° angle. The continuous pipe and the end of the pipe are connected to this pipe fitting with a T. The pipes are fixed with three screws. Finish: untreaded aluminum

Double-shell/single-shell pipe connector with three outlets for connecting two pipes at variable angles. A continuous pipe and a pipe end are connected to a T using this pipe connector. The continuous tube is clamped by two half-shells. The pipe end is fixed in the pipe connector with a grub screw. The angle can be adjusted individually. Finish: untreaded aluminum

Two-shell pipe fitting with four outlets. With this pipe fitting, a continuous pipe and two pipe ends are connected to form a cross, attaching two halves. Finish: untreaded aluminum

Single body four outlet pipe fitting for connecting three pipes with five 90° elbows. The continuous pipe and the two pipe ends are connected to this pipe joint at the corner. With this pipe fitting, the pipes are fixed with four screws. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening the two screws and sleeve nuts. The screw and sleeve are connected to each other through the holes. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum