Type 3371, Corner connection 90° header Ø 33,7 mm untreaded

Double body pipe fitting with three outlets and two 90° angles for connecting pipes. The continuous pipe and the end of the pipe are connected to the T by this pipe fitting, fixing the two halves. Finish: untreaded aluminum

Single body four outlet pipe fitting for connecting three pipes with five 90° elbows. The continuous pipe and the two pipe ends are connected to this pipe joint at the corner. With this pipe fitting, the pipes are fixed with four screws. Finish: untreaded aluminum

One-body pipe fitting with an outlet for vertical attachment of the pipe to the surface. The pipe fitting has a round base plate with four holes for fixing. The end of the pipe is fixed in the pipe fitting with two screws. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with two holes for fastening. The slotted wall bearing is clamped tightly around the pipe by tightening a screw. The screw and sleeve are connected to each other through the hole. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for attaching a pipe to a corner. The pipe connector consists of two individual parts, each with a wall mounting plate. The mounting plates can be variably rotated to any angle. This pipe connector can be used to attach pipes to inside and outside corners. Finish: untreaded aluminum

Double-shell pipe connector with two outlets for connecting a continuous pipe to a plate or glass pane. The pipe is connected to the plate/glass pane using this pipe connector by clamping two half-shells. Finish: untreaded aluminum