Type 46, Double Swivel Ø48,3

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Flange with toeboard adaptor. Extra-heavy footplate for attachment against a shovel edge. Usually used on roofs.

Crossover 90°. Crossover clamp (90°). Used for long tube intersections with uprights where decreasing cutting cost and increasing strength of the system with continuity of the tube is desired.

Reducing Crossover 90°. Used as Type 28. reduction fitting makes it possible to design structures in two different tube diameters - horizontal Ø60.3 and vertical Ø48.3mm.

Double-Sided Panel Clip. Two-sided mesh panel clip.

Metal cap for Ø42,4 mm tube
Color: black

Cover caps are designed to close and finish pipe ends.
These caps are not intended to cover the clamp holes.