Type 5114, Angle joint connector Ø 48,3 mm untreaded

Type 2230, 180° Swivel bearing for self closing gate Finish: untreaded aluminum

Double-shell pipe fitting with two outlets for connecting two pipes at a 90° angle. With this pipe fitting, two pipe ends are joined to form a 90° angle by attaching two halves. The screw and sleeve are connected to each other through holes. Therefore, the pipe fitting is suitable for higher tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with four outlets for connecting two pipes with five 90° angles. A continuous pipe and two pipe ends are connected to a corner with this pipe connector. The pipes are fixed by three grub screws. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for vertically attaching a pipe to a surface. The pipe connector has a round base plate with four holes for fastening. The pipe end is fixed in the pipe connector with two grub screws. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The pipe end is fixed in the pipe connector with two grub screws. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for connecting two pipes in the same axis. The pipe ends can be butted in the pipe connector. The pipes are fixed by two grub screws. Finish: untreaded aluminum