Type 53, Side Palm Ø48,3

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Adjustable Knee Piece. Variable elbow fitting. This tubefitting can make a minimum angle of 75 degrees to a maximum of 210 degrees.

Clamp-On Crossover. 90° crossover joint fitting for adding to an existing structure.

Corner Swivel 90°. Swivel fitting for variable angle fixing for a corner post.

Collar Plate Single Side. Front adjustment scew. Fitting for panel fixing.

Double-Sided Panel Clip. Two-sided mesh panel clip.