TUBEX Clamps

The clamps are made of hot-dip galvanized malleable iron, painted black. Not suitable for outdoor use! Comply with TÜV requirements.

Short T-piece - 40 mm. Forms a perpendicular connection between two tubes. Upper fitting for straight, horizontal railing supports. This fitting can not be used for horizontal tube connections in the fitting itself.

Short Tee. Provides a perpendicular connection between two tubes. Top fitting for straight and level railing uprights. This fitting cannot be used to join a horizontal tube within the fitting.

Short Slope Tee Variable angle 0° - 11°. Top fitting for up to 11° uprights. This fitting can not be used to join horizontal tube within the fitting.

Short Tee 45°. Forms a connection between two tubes at an angle of 45°.

The clamps are made of hot-dip galvanized malleable iron, durable, corrosion-resistant and long-lasting. Comply with TÜV requirements.

Elbow 90°. Elbow joint fitting used as an end fitting for the top rail.

Slope Elbow 90° Variable angle 0° - 11°. Elbow joint fitting used as an end fitting for the top rail up to 11°.

Suitable for end connection.

Wall Flange. This clamp is used on structures where positional fixing is required. Do not use as a base flange to support guard railings or similar systems.

Short Tee, long.
Same as type 2 but longer, with three adjusting screws.

Reducing Short Tee. Used as Type 2. Rediction fitting makes it possible to design structures in two different tube diameters.

Long Tee. Similar to Type 2. This fitting can be used where a join is required in the horizontal tube.

The clamps are made of hot-dip galvanized malleable iron, durable, corrosion-resistant and long-lasting. Comply with TÜV requirements.

Round base plate open. This tubefitting is suitable for constructions where the pipe has to run through. Suitable for the use of e.g. intermediate shelves.

Three-way elbow 90° - 40 mm. Angle connection clamp (90°) for corners of overheads and all other angled connections.

The clamps are made of hot-dip galvanized malleable iron, painted black. Not suitable for outdoor use! Comply with TÜV requirements.

Round base plate with inlay (SET). Excellently suitable as rod holder. Supplied as a set (left and right version). After you have placed the round foot plates, you can simply insert the tube. Also suitable for temporary removal of a passageway, where the tube can be removed easily and quickly.

Angle of continuous upright - 40 mm. Corner connection (90°), where the vertical tube runs through the clamp.

Straight Coupling. Joint clamp for tubes of the same diameter. Do not use for heavy vertical loads. Alternative clamp is Type 9 used as an internal spigot.

The clamps are made of hot-dip galvanized malleable iron, painted black. Not suitable for outdoor use! Comply with TÜV requirements.

The clamps are made of hot-dip galvanized malleable iron, painted black. Not suitable for outdoors! Comply with TÜV requirements.

Three Way Top Corner. Corner joint (90°) clamp used for top rail corners and any other rectangular system.

Two Socket Cross - 40 mm. 90°- joint clamp between the middle rail and an upright on railings.