Type 310, Add-on Short Tee Ø48,3

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Angle Cross 0°- 45°. Connection clamp between the middle rail and the railing posts of sloping railings up to 45°.

Crossover 90°. Crossover clamp (90°). Used for long tube intersections with uprights where decreasing cutting cost and increasing strength of the system with continuity of the tube is desired.

Clamp-On Tee. Used for adding to and modifying an existing structure.

Clamp-On Crossover. 90° crossover joint fitting for adding to an existing structure.

Collar Plate Double Side. Panel fixing with two lugs is also used for locking gates.