Type 3395, Centre prop Ø 33,7 mm untreaded

Single-shell pipe fitting with four outlets for connecting three pipes at four 90° angles. A continuous tube and two tube ends are connected to form a cross. With this pipe fitting, the pipes are fixed with four screws. Finish: untreaded aluminum

Double-shell pipe fitting with two outlets for connecting two pipes at a 90° angle. With this pipe fitting, two pipe ends are joined to form a 90° angle by attaching two halves. The pipe ends are drilled twice to Ø 9.5 mm. The screw and sleeve are connected to each other through holes. Therefore, the pipe fitting is suitable for higher tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for vertically attaching a pipe to a surface. The pipe connector has a base plate with two holes for fastening. The pipe end is fixed in the pipe connector with a grub screw. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The pipe end is fixed in the pipe connector with two grub screws. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening the two screws and sleeve nuts. The screw and sleeve are connected to each other through the holes. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Type 2230, 180° Swivel bearing for self closing gate Finish: untreaded aluminum