Type 3314, Angle joint connector Ø 33,7 mm untreaded

Single-shell pipe fitting with two outlets for connecting two pipes at a 90° angle. With this pipe fitting, two pipe ends are fixed with two screws. Finish: untreaded aluminum

One-body pipe fitting with an outlet for vertical attachment of the pipe to the surface. The pipe fitting has a round base plate with four holes for fixing. The split base bearing is tightly fixed around the pipe by tightening the two screws and the sleeve nut. The screw and the sleeve are connected to each other through holes. Therefore, the pipe fitting is suitable for higher tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for vertically attaching a pipe to a surface. The pipe connector has a base plate with two holes for fastening. The pipe end is fixed in the pipe connector with a grub screw. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening the two screws and sleeve nuts. The pipe is drilled twice with a diameter of 9.5mm. The screw and sleeve are connected to each other through the holes. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for attaching a pipe to a corner. The pipe connector consists of two individual parts, each with a wall mounting plate. The mounting plates can be variably rotated to any angle. This pipe connector can be used to attach pipes to inside and outside corners. Finish: untreaded aluminum

Single body pipe fitting with single pipe end outlet. This clamp can be combined with clamp 3316 to form a T or a cross. The pipe is fixed in the pipe fitting with a screw. Finish: untreaded aluminum