Type 3321, T-joint connector Ø 33,7 mm untreaded

Single-shell pipe fitting with three outlets for connecting two pipes with a 90° angle. The continuous pipe and the end of the pipe are connected to this pipe fitting with a T. The pipes are fixed with three screws. Finish: untreaded aluminum

Two-shell pipe fitting with four outlets. With this pipe fitting, a continuous pipe and two pipe ends are connected to form a cross, attaching two halves. Finish: untreaded aluminum

One-body pipe fitting with an outlet for vertical attachment of the pipe to the surface. The pipe fitting has a round base plate with four holes for fixing. The split base bearing is tightly fixed around the pipe by tightening the two screws and the sleeve nut. The screw and the sleeve are connected to each other through holes. Therefore, the pipe fitting is suitable for higher tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for parallel attachment of a pipe to a surface. The pipe connector has a wall plate with two holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening a screw and sleeve nut. The screw and sleeve are connected to each other through the hole. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for parallel attachment of a pipe to a surface. The pipe connector has a narrow base plate with two holes for fastening. Finish: untreaded aluminum

Single body pipe fitting with single pipe end outlet. This clamp can be combined with clamp 3316 to form a T or a cross. The pipe is fixed in the pipe fitting with a screw. Finish: untreaded aluminum