Type 3302, Wall bearing Ø 33,7 mm untreaded

Double-shell/single-shell pipe connector with three outlets for connecting two pipes at variable angles. A continuous pipe and a pipe end are connected to a T using this pipe connector. The continuous tube is clamped by two half-shells. The pipe end is fixed in the pipe connector with a grub screw. The angle can be adjusted individually. Finish: untreaded aluminum

Single-shell pipe fitting with three outlets for connecting three pipes at three 90° angles. The pipe ends are connected to the corner (header) using this pipe fitting. With this pipe fitting, the pipe ends are fixed with three screws. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The pipe end is fixed in the pipe connector with two grub screws. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening the two screws and sleeve nuts. The screw and sleeve are connected to each other through the holes. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a narrow base plate with two holes for fastening. The slotted end support is clamped tightly around the pipe end by tightening the screw and sleeve nut. Finish: untreaded aluminum

Type 2230, 180° Swivel bearing for self closing gate Finish: untreaded aluminum