Type 3329, T-joint connector Ø 33,7 mm untreaded

Single-shell pipe fitting with three outlets for connecting two pipes with a 90° angle. The continuous pipe and the end of the pipe are connected to this pipe fitting with a T. The pipes are fixed with three screws. Finish: untreaded aluminum

Double-shell pipe fitting with two outlets for connecting two pipes at a 90° angle. With this pipe fitting, two pipe ends are joined to form a 90° angle by attaching two halves. The pipe ends are drilled twice to Ø 9.5 mm. The screw and sleeve are connected to each other through holes. Therefore, the pipe fitting is suitable for higher tensile forces. Finish: untreaded aluminum

One-body pipe fitting with an outlet for vertical attachment of the pipe to the surface. The pipe fitting has a round base plate with four holes for fixing. The split base bearing is tightly fixed around the pipe by tightening the two screws and the sleeve nut. The screw and the sleeve are connected to each other through holes. Therefore, the pipe fitting is suitable for higher tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with four holes for attachment. The pipe end is fixed in the pipe connector with two grub screws. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a narrow base plate with two holes for fastening. The slotted end support is clamped tightly around the pipe end by tightening the screw and sleeve nut. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a narrow base plate with two holes for fastening. The slotted end support is clamped tightly around the pipe end by tightening the screw and sleeve nut. Finish: untreaded aluminum