Type 3345, Angle-Connector 90° Ø 33,7 mm untreaded

Double-shell/single-shell pipe connector with three outlets for connecting two pipes at variable angles. A continuous pipe and a pipe end are connected to a T using this pipe connector. The continuous tube is clamped by two half-shells. The pipe end is fixed in the pipe connector with a grub screw. The angle can be adjusted individually. Finish: untreaded aluminum

Single-shell pipe fitting with four outlets for connecting three pipes at four 90° angles. A continuous tube and two tube ends are connected to form a cross. With this pipe fitting, the pipes are fixed with four screws. Finish: untreaded aluminum

One-body pipe fitting with an outlet for vertical attachment of the pipe to the surface. The pipe fitting has a round base plate with four holes for fixing. The split base bearing is tightly fixed around the pipe by tightening the two screws and the sleeve nut. The screw and the sleeve are connected to each other through holes. Therefore, the pipe fitting is suitable for higher tensile forces. Finish: untreaded aluminum

One-body pipe fitting with an outlet for vertical attachment of the pipe to the surface. The pipe fitting has a round base plate with four holes for fixing. The end of the pipe is fixed in the pipe fitting with two screws. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a rectangular wall plate with two holes for fastening. The slotted wall bearing is clamped tightly around the pipe by tightening a screw. The screw and sleeve are connected to each other through the hole. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for parallel attachment of a pipe to a surface. The pipe connector has a narrow base plate with two holes for fastening. Finish: untreaded aluminum