Type 3393, End prop Ø 33,7 mm untreaded

Double-shell pipe fitting with two outlets for connecting two pipes at a 90° angle. With this pipe fitting, two pipe ends are joined to form a 90° angle by attaching two halves. The pipe ends are drilled twice to Ø 9.5 mm. The screw and sleeve are connected to each other through holes. Therefore, the pipe fitting is suitable for higher tensile forces. Finish: untreaded aluminum

Single-shell pipe fitting with three outlets for connecting three pipes at three 90° angles. The pipe ends are connected to the corner (header) using this pipe fitting. With this pipe fitting, the pipe ends are fixed with three screws. Finish: untreaded aluminum

Single-shell pipe connector with two outlets for parallel attachment of a pipe to a surface. The pipe connector has a wall plate with two holes for attachment. The slotted wall bearing is clamped tightly around the pipe by tightening a screw and sleeve nut. The screw and sleeve are connected to each other through the hole. The pipe connector is therefore suitable for larger tensile forces. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for attaching a pipe to a corner. The pipe connector consists of two individual parts, each with a wall mounting plate. The mounting plates can be variably rotated to any angle. This pipe connector can be used to attach pipes to inside and outside corners. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a narrow base plate with two holes for fastening. The slotted end support is clamped tightly around the pipe end by tightening the screw and sleeve nut. Finish: untreaded aluminum

Single-shell pipe connector with an outlet for parallel attachment of a pipe to a surface. The pipe connector has a narrow base plate with two holes for fastening. The slotted end support is clamped tightly around the pipe end by tightening the screw and sleeve nut. Finish: untreaded aluminum