Type 91, Ridge Fittings 27½° Ø48,3 mm

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Round tube D=48.3mm
wall thickness 2.9 mm
painted black with powder
maximum profile length 2 m

Collar. Support fitting to increase the slip resistance of fittings that are under high loads.

Adjustable Short Variable angle 45° - 60°. This adjustable angle clamp is used to join tubes between 45° and 60°. Use for diagonal braces, struts and an angled top rail joint to vertical posts on stairs.

Designed to attach a freestanding handrail to an upright post on a variable angle.

The 752 Interclamp fitting is designed for intermediate support of horizontal galvanised handrail tubes where no joining of the tubes are required. They are also used when fitting the 724 Assist handrail end termination to the upright post.

Metal cap for Ø42,4 mm tube
Color: black

Cover caps are designed to close and finish pipe ends.
These caps are not intended to cover the clamp holes.