Type 280, Add-on Crossover 90° Ø48,3

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

Wall Flange. This clamp is used on structures where positional fixing is required. Do not use as a base flange to support guard railings or similar systems.

Long Tee. Similar to Type 2. This fitting can be used where a join is required in the horizontal tube.

Groundsocket. A ground socket fitting inside the concrete for fixing upright tube. Post is retained with a locking setscrew, allowing easy insertion and removal (if necessary).

Pin Hinge. Male hinge fitting, to be used in combination with type 62.

Galv. Eves Fittings 27½°. This tube fitting is used for roof construction and is usually in combination with type 91.