Type 5, Swivel Tee Ø48,3

Add-on Side Outlet Tee. The same tube fitting as type 24, but this tube fitting can be placed on an existing construction by means of a foldable part on the vertical tube connector.

Base flange for sloping sites, adjustable from 30° to 45°. As the fixing holes in the base cannot be fixed in line with the applied load, it is only intended for light loads or structures which are sufficiently supported by virtue of their design. Where a greater load is required, type 132 is normally used, with the upright tube bent to the required angle.

The 751 fitting is designed for intermediate support of horizontal galvanized handrail tubes where no joining of the tubes is required.

Galv. Variable Elbow 40° - 70°. Elbow coupling as end stop for the overhead rail with a variable angle of 40 ° - 70 °. Usually used for handrails on stairs.

Two Socket Cross. 90° joint clamp between the middle rail and an upright on railings.

Single Swivel. Swivel fitting for variable angle fixing.